![]() ![]() ![]() It is extremely important to reinstall the connector reversed from the current orientation so the fans will not run at full speed.ĭisconnect the thermal sensor by pulling its connector away from the side of the hard drive.ĭuring reassembly, be sure that the thermal sensor connector is connected to set of pins closest to the SATA connectors. You can see the current temperature and fan speed from the. Select Auto to return to the default settings. Launch Macs Fan Control, then click on the Custom button to manually adjust the speed of the Mac fans based on either a constant RPM value or a sensor-based temperature value. OR - am i missing the point all together.i am thinking the thermal sensor is the 4 pin connector on the hard drive next to the sata and power connectors? Are there versions of drives out there where there are more than 4 pins?īefore disconnecting the thermal sensor cable, take note of its orientation. Get Macs Fan Control free from the developer here. ![]() I think i read it wrong however.i put it back in the original orientation and now my fan is on high all the time.ĭoes it make sense to have to reverse the fan cable orientation when changing drives? In the procedure it noted to be aware of the fan control connector position on the HD, and that installing reverse would cause it to run on high. I have a 21 inch Imac and i recently changed the 500g HD for a 1G. I have a similar problem but for a different reason. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |